A Customer is Traveling to a Branch Office Static Ip

There are many reasons that you may need to alter and gear up a static IP address for your IP device, such equally a managed switch, wireless router, or outdoor access betoken. Ane reason is because an installation scenario doesn’t have an active network with DHCP services. Some other reasons you may need to set a static IP are because yous utilise a dedicated web server, host server, VPN, or VoIP services.

Setting static IP addresses tin can assist to avoid network conflicts which could cause certain devices to end working correctly. However, in most installation scenarios, users volition utilise a regular network and will not need to use a static IP. Setting a static IP address is an avant-garde networking part, and a basic, cardinal knowledge of TCP/IP is needed.

In full general, statically address devices outside of your DHCP pool range, which in nigh home networks is your router. For reference, the DHCP puddle range for TRENDnet products is usually (only not always) 192.168.10.101 to 199.

1. Admission the Command Panel

In the Windows search bar, blazon in “ncpa.cpl” and then printing enter.

If you are non using Windows x, follow the steps below instead.

1. On your keyboard, press the “Windows” and “R” keys at the same fourth dimension.
2. Enter “ncpa.cpl” in the window that pops upward.

Annotation: Network connections volition display the network adapters that are currently connected to your calculator.

two. Select the Network Adapter

Right click on the network adapter that is currently connected to the device that you are trying to configure. Usually, it will exist the adapter with the word “Ethernet” in the proper name.

3. Select Properties

Select “Properties” from the driblet-down carte du jour.

4. Select Internet Protocol Version four (TCP/IPv4)

Double-click on “Internet Protocol Version 4 (TCP/IPv4)”.

5. Manually enter IP accost and subnet mask

Select “Use the post-obit IP Address” and so input the post-obit information in the respective fields:

IP address: Check the device that you are connected to in order to locate the IP address. The first iii sets of digits should match. For this tutorial, nosotros will use IP address 192.168.10.10.

Subnet mask: The subnet mask betwixt the device that you lot are trying to connect to needs to exist the same every bit your PC. For this tutorial, we will utilise subnet mask 255.255.255.0

half dozen. Salvage Settings

Click the OK button on “Internet Protocol Version 4 (TCP/IPv4) Properties” window, and also click the OK push button on “Ethernet Properties” window.

Note: The OK buttons must exist clicked in both instances or your settings will not be saved.

vii. Revert Dorsum to DHCP

To fix your computer back to DHCP, echo steps 1-four over again. When you get to the “Internet Protocol Version four (TCP/IPv4) Backdrop” window, click “Obtain an IP address automatically”. This will allow your PC to be assigned a random IP address on your network.

Note: The OK buttons must exist clicked in both instances or your settings will not exist saved.

Glossary